The study of Influencing Maintenance Factors on Failures of Two gypsum Kilns by Failure Modes and Effects Analysis (FMEA)
Abstract
After the study of gypsum production steps in the factories, FMEA was conducted by the determination of analysis insight, information gathering, making list of kilns’ component and filling up the FMEA’s tables. The effects of failures on production, how to fail, failure rate, failure severity, and control measures were studied. The evaluation of maintenance system was studied by a check list including questions related to system components. The costs of failures were determined by refer in accounting notebooks and interview with the head of accounting department.
It was found the total qualities of maintenance system in NO.1 was more than NO.2 but because of lower quality of NO.1’s kiln design, number of failures and their costs were more. In addition it was determined that repair costs in NO.2’s kiln were about one third of NO.1’s. The low severity failures caused the most costs in comparison to the moderate and low ones.
The technical characteristics of kilns were appeared to be the most important factors in reducing of failures and costs.
Keywords
Full Text:
PDFReferences
US CENSUS BUREA. Gypsum product manufacturing: 2002.
Mobbs, P.M. The Mineral Industry of Iran. at URL http:// www.parstimes .com/library /mineral_industry_2002.pdf.
McDermott,R.E.,Mikulak,R.J., Beauregard, M.R. The basic of FMEA. Resource Engineering. ISBN: 0-527-76320-9. (in Farsi), 1996
Almannai, B., Greenough, R., Kay, J. A decision support tool based on QFD and FMEA for the selection of manufacturing automation technologies, Robotics and Computer-Integrated manufacturing, 2007
Eti,M.C, Ogaji, SOT, Probert, SD Implementing total productive maintenance in Nigerian, Applied Energy, 2004;79(4): 385-01.
Darligton, JF, Booker,JD Development of design technique for the identification of fatigue initiating features, Engineering Failure Analysis, 2006;13(7): 1134-52
Spath, P.L. Using failure mode and effects analysis to improve patient safety, ARON, 2003;78(1): 15-37.
Duwe, B, Fuchs, BD, Hensen-Flachen, J. Failure mode and effect analysis application to critical care medicine, Critical Care Clinics, 2005;21(1): 21-30.
Mirmohammad, A. Gypsum, Production and Applications. Iran Gach Company.(in Farsi), 1982
White, J. Maintenance and Repair. Jahade Daneshgahi, Industrial Engineering Department. (in Farsi) ;1984
Rhee, S.J., Ishii, K. Using cost based FMEA to enhance reliability and serviceability, Advanced Engineering Informatics, 2003;17 (3-4):179-88.
Sharma, RK, Sharma, P. () "System failure behavior and maintenance decision making using, RCA, FMEA and FM", Journal of Quality in Maintenance Engineering, 2010; 16( 1): pp.64 – 88.
Iranian Journal of Health, Safety and Environment e-ISSN: :2345-5535 Iran university of Medical sciences, Tehran, Iran